- UPS: ... TeraStation may have stopped working if a UPS device was connected.

- Antivirus: Fixed a bug where ... a message when the update is finished.

- USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.

How to Use the Updater:

1. Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.

For example, if the IP address and subnet mask of the computer are

" 192.168.0.10 , 255.255.255.0 "

and the IP address and subnet mask of the TeraStation are

" 192.168.1.150 , 255.255.255.0 "

then the updater will _not_ work properly.

In this case, reconfigure the TeraStation's IP address and subnet mask to

" 192.168.0.150 , 255.255.255.0 ".

Then they will be on the same subnet and the updater will work properly.

2. Close all applications. Also, stop or exit any firewall software.

3. Extract the downloaded file and run "TSUpdater.exe". When a TeraStation is detected, an update window will open.

4. Select the TeraStation to update if multiple TeraStation are connected.

5. Click "Update" and enter the TeraStation's admin password.

6. Click "OK".

7. Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.

8. When the update finishes, a message will be displayed.

About Network-Attached Storage Updates:

Upgrading the Network-Attached Storage (NAS) firmware can improve the system’s overall performance, stability, and security by adding various ...