For example, if the IP address / subnet mask of the computer is

"192.168.0.10 / 255.255.255.0"

and the IP address / subnet mask of the LinkStation is

"192.168.1.150 / 255.255.255.0",

then they will not work together properly.

In such a case, reconfigure the values for the LinkStation to

" 192.168.0.150 / 255.255.255.0 "

2. Exit all applications. Also, disable or exit any firewall software. You may resume firewall after the update is complete.

3. Extract the downloaded file and run LSUpdater.exe . When a LinkStation is detected, an update window will open.

4. If multiple LinkStation units are connected, select which unit to update.

5. Click 'Update' and enter the LinkStation's admin password.

6. Click 'OK'.

7. The firmware will begin updating. The info LED will flash during the update process.

8. When update is complete, a message will appear.

Notes

- Do not turn the unit or the hub off until the update is finished.

- The update will take several minutes. If it times out after 10 minutes or more, reboot the LinkStation and try again.

Note: If your LinkStation is in EM mode, reboot it and try again.

- Do not access your LinkStation while updating firmware.

- If the firmware update fails due to inconsistent wireless connectivity, connect your PC via a wired connection, then try again.

- Update may fail if the computer downloading the firmware has multiple network interfaces enabled. Disable any unnecessary network interfaces and try again.

- USB drives are not mounted ...