Version History:

V3.1.3 to V3.1.4

- Now supports Yamaha reface CS/DX/CP/YC.

- The USB-MIDI Driver is no longer available for Windows 2000/Vista/XP.

The USB-MIDI driver is software that transfers MIDI data back and forth between PC software and Yamaha USB-MIDI devices.

Yamaha USB-MIDI Driver Installation (for Windows)

1 Disconnect all USB devices from the computer except for the mouse and computer keyboard.

2 Start the computer and log on to the Administrator account. Exit from any open applications and close all open windows.

3 Turn off the power of the instrument.

4 Connect the USB connector of the computer to the USB TO HOST connector of the MIDI instrument with a standard USB cable.

If your instrument has a HOST SELECT switch, set the switch to “USB.” NOTE Do not use a USB hub for connecting multiple USB devices.

NOTE If you are using several MIDI instruments with USB connection at the same time, connect all the instruments to the computer and turn on the power for all of them, then perform the following installation procedure.

5 Turn on the power of the instrument(s).

6 When the “Found New Hardware Wizard” window appears, click [Cancel]. NOTE This screen will not appear on Windows

NOTE If you have already used the instruments via a standard driver in your operating system, this screen will not appear. Go on to the next step.

NOTE On some computers, it may take a few minutes before this screen appears.

7. When the message “Device driver software was not successfully installed.” appears, continue the installation procedure.

7 After the downloaded compressed file is properly extracted, double-click the file “setup.exe.”

The “Preparing to install” window appears. The next window will appear after finishing this preparation.

NOTE (Windows Vista/7) If the “User Account Control” window ...