- 3-Tap parallel with Medium configuration is now available. Feature was lost since driver 1.50.

- Fixed support for time stamp in msec. It would return values in usec.

- Buffer host PC time stamp would be ' 0' except for 1st frame of a sequence when EXT_TRIGGER_FRAME_COUNT > 1.

- Random buffer host PC time stamp = 0 when grabbing from dual channel camera.

- Improved prevention of BSOD upon reset of the board that can occur in some computers. Solution needs SaperaLT 7.40 and up.

- Windows 8 hybrid shutdown in combination with adding/removing board(s) in between reboots can cause boards not to be mapped properly on some PCs. If this is the case, a restart of the PC will be requested by TDALSA Device Manager.

- Under Windows 8, driver will not create tiles anymore and will create a proper Application group containing the driver's tools and documentation.

- Strobe Output would be pulled low before being set to tri-state when disabling the output causing possible glitch if strobe is set to active low.

About Device Driver: 

If you install this package, your device will be properly recognized by compatible systems, and might even benefit from new features or various bug fixes.

Please note that, even though other operating systems might also be compatible, we do not recommend you apply any software on platforms other than the specified ones. Doing so might cause the installation to crash, which could even render the device unusable.

When it comes to installing the package, the steps should not be much of a hassle because each manufacturer tries to make them as easy as possible; usually, you must make check for compatibility, get the package, run the available setup, and follow the instructions displayed ...