- Modified to deal with Samba programming ... contains specific symbols.

How to Update the Firmware

1. Connect the LinkStation to the computer that will run the updater, and make sure both devices are on the ... the IP address / subnet mask of the LinkStation is

"192.168.1.150 / 255.255.255.0",

then they will not ... such a case, reconfigure the values for the LinkStation to

" 192.168.0.150 / 255.255.255.0 "

2. Exit ... downloaded file and run LSUpdater.exe . When a LinkStation is detected, an update window will open.

4. If multiple LinkStation units are connected, select which unit to update.

5. Click 'Update' and enter the LinkStation's admin password.

6. Click 'OK'.

7. The firmware will begin updating. The info LED will flash ... out after 10 minutes or more, reboot the LinkStation and try again.

Note: If your LinkStation is in EM mode, reboot it and try again.

- Do not access your LinkStation while updating firmware.

- If the firmware update fails due to inconsistent wireless connectivity, connect ... Update may fail if the computer downloading the firmware has multiple network interfaces enabled. Disable any unnecessary ... USB drives are not mounted automatically after a firmware update. Unplug and then reconnect them after the update.

Notification

- After this firmware update, EXT3-formatted USB drives will be read-only.

How to Check Your Firmware Version

Select your LinkStation from the NAS Navigator2 window. The firmware version is displayed in the bottom of right ... the screen.

How to Check if Your LinkStation is in EM Mode

Select your LinkStation from the NAS Navigator2 window. If your unit's ...