→ Continuous (control on LCD) is when a normally open switch pedal is used

→ Switched (Inv control on LCD) is when either a continuous pedal or a ... sent

- MMC on MIDI DIN out

- LCD display readable with a PSU of over 5.5V

- Sustain pedal's display: no more "0000"

- Faders position detection more stable

- Removed memory

- Non-validated parameters' value are not displayed anymore

- Patch change's MSB editable from KL88

- Pad note: correct display

- pitch wheel channel is consistent with the part channel chosen

About Device Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, ...