2. Fix possible erroneous failure alarm and shutdown of permeation oven option that was introduced in version 02.00.06.

3. Fix lrec and srec CLINK commands to respond with only line feed character after each record and carriage return and line feed after the last record to correct ... after the enter key is pressed.

5. Add support for new processor board revision 1.5T.

UPGRADE ... that iPort is already talking to the instrument and the instrument window is currently open.

NOTE:

1. Close ... There may be some error messages regarding configuration and calibration files that are displayed, this is normal ... a firmware update. At this time, the bootloader and application code in each of the low-level processors ... updates were successful, go to the ALARMS menu and make sure the board status alarms at the ... status alarms show “FAIL”, try rebooting the instrument and checking the ALARMS menu again. If they still ... workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the ... mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes ... steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you ... button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you ... to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can ...