Fireface 802: USB 13, DSP 9, FW 7, Class Compliant 9

Supports unlimited CRM channel selection and the new reverbs. DSP mixer has been optimized. Compatible to the Corning USB 3 optical cable. Supports Loopback and EQ+D for record under iOS.

How to use:

Start fut_usb.exe. The program will show you the current revision of your unit, and whether it needs an update or not. If so, then simply press the 'Update' button. A progress bar will indicate when the flash process is finished (Verify Ok).

If more than one unit is installed, all units can be flashed by changing to the next tab and repeating the process.

After the update the unit needs to be reset. This is done by powering down the UC/Babyface for a few seconds. A reboot of the computer is not necessary.

When the update fails (status: failure), the unit's second BIOS will be used from the next cold boot on (Secure BIOS Technology). Therefore the unit stays fully functional. The flash process should then be tried again on a different computer.

Firface UC: In case the automatic activation of the second BIOS does not work, push and hold the front knob during power-on.

Important notes:

The Flash Update Tool updates the UC / UCX / UFX / Babyface firmware to the latest revision. An installed driver is required.

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device ...