Improvements:

- Now supports Windows 10.

Important notice:

- The hardware specification for DME Firmware V3.5x or earlier differs from the one for Firmware V3.8x or later (including V4.0). Therefore firmware V3.5x or earlier cannot be upgraded to V3.81 or later. Also, firmware V3.81 or later cannot be downgraded to V3.5x or earlier. (This does not apply to the SP2060 or ICP1.) If you need to upgrade your DME from V3.5x or earlier to V3.81 or later (including V4.0), please contact your Yamaha dealer.
- It is needless to change the DME hardware when you need to upgrade/downgrade between V3.8x and V4.00 or later. Please download the required firmware version from our download page and update your DME by using DME Designer.
- Save an up-to-date DME project file (*.daf). Don't update unless an up-to-date ".daf" file has already been saved on your computer. Without the ".daf" file, you will not be able to restore DME operation.
- DME Designer V4 cannot design/control the system that consists of DME Firmware V3 units or the mixed system with Firmware V3 and V4 units. It is required to unify the system version to V3 or V4 by upgrading/downgrading DME Designer or firmware.
- It is necessary to update DME Satellite firmware to V4.05 in order to connect with a Windows 10 PC that has DME Designer Ver.4.0.0 installed. If it is connected with a DME satellite that has firmware Ver.4.00 – 4.04 installed, the DME Designer will not operate normally.

Installation steps:

- You need DME Designer to install the firmware.

About Firmware Update:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, ...