- UPS: Fixed a bug where the E10 error message kept displaying if a specific UPS device was connected by a serial cable.

- UPS: Fixed a bug where the TeraStation may have stopped working if a UPS device was connected.

- Antivirus: Fixed a bug where antivirus became disabled when waking up from sleep mode.

- Settings: Fixed a bug where the username was displayed on the "Email Address" box when verifying the user account information.

- Settings: Fixed a bug where the "Confirm Operation" window appeared corrupted on certain browsers.

Caution:

- Please consult your local technical support representative if you experience any problems caused by this firmware update.

- Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.

- USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.

How to Use the Updater:

1. Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.

For example, if the IP address and subnet mask of the computer are

" 192.168.0.10 , 255.255.255.0 "

and the IP address and subnet mask of the TeraStation are

" 192.168.1.150 , 255.255.255.0 "

then the updater will _not_ work properly.

In this case, reconfigure the ...