Version 02.02.09 changes from version 02.02.07:

1. Added Modbus write coils to change the range on the 81i-H: Range 20, Range 30, Range 50 and Range 300.

2. Fix "set format", "set lrec format", "set srec format", and "set erec format" CLINK commands to save the new setting if the source of the command is serial.

3. Fixed "set program bootloader procboard" CLINK command so that it no longer causes iSeries+ units to hang.

4. The "host name" CLINK command now responds with a if no host name is found. If "set host name" data does not pass validation, it now responds with "data not valid" instead of "bad command".

5. 81i-H cooler set points for each concentration range are now individually settable and saved.

UPGRADE FIRMWARE

Below is a procedure for loading the firmware into FLASH memory. The firmware update file transfer process should take about 30 minutes at 57,600 baud. It is assumed that iPort is already talking to the instrument and the instrument window is currently open.

NOTE:

DO NOT TURN OFF THE INSTRUMENT AT ANY TIME DURING THIS UPDATE If the instrument is turned off while burning the new image to the FLASH, it may require replacement of the CPU board, motherboard, I/O expansion board, and/or measurement interface board. To reduce this risk, make sure the instrument is running on clean and stable power before performing this update.

1. Close all instrument windows.

2. From the iPort menu, select Instrument > Update Firmware. Select TCP/IP or Serial, depending on the connection.

3. In the Update Instrument Firmware Program dialog box, enter the instrument ID (if using serial port) or the TCP/IP address (if using TCP/IP).

4. In the Open File dialog box, select the firmware update file, then click the Open button.

5. ...